Zanussi ZFC 62/23 FF, Instruction Booklet

6

THE ELECTRICAL CONNECTIONS

WARNING: THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should this safety 
measure not be observed.

If the plug that is fitted to your appliance is not 
suitable for your socket outlet, it must be cut off and 
the appropriate plug fitted.

Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to 
prevent the hazard of shocks in case it should be 
plugged into a 13amp socket in another part of your 
home.

Important

The wires in the mains lead are coloured in 
accordance with the following code:

Green and Yellow

- Earth

Blue

- Neutral

Brown

- Live

If you fit your own plug, the colours of the wires in 
the mains lead of your appliance may not 
correspond with the markings identifying the 
terminals in your plug, proceed as follows:

Fig. 4

Connect the Green and Yellow (earth) wire to the 
terminal in the plug which is marked with the letter 
«E» or the earth symbol 

, or coloured green and 

yellow.

Connect the blue (neutral) wire to the terminal in 
the plug which is marked with the letter «N» or 
coloured black.

Connect the brown (live) wire to the terminal in the 
plug which is marked with the letter «L» or 
coloured red.

The plug moulded onto the lead incorporates a fuse. 
For replacement, use a 13amp BSI362 fuse. Only 
ASTA or BSI approved fuses should be used.

The plug must not be used if the fuse cover/carrier 
is lost. The cover/carrier is indicated by the coloured 
insert at the base of the plug.

D207

GREEN & YELLOW

13 AMP. FUSE

BROWN

CORD CLAMP

BLUE

13 AMP

A replacement cover/carrier must be obtained from 
your local Zanussi Service Centre whose address is 
listed in the Customer Care Booklet which 
accompanies your instruction manual.

This appliance complies with the E.E.C. Directive No. 87/308 
of 2.6.87 relative to radio interference suppression.

This appliance complies with the following 
E.E.C. Directives:

-

73/23 EEC

 of 19.2.73 (Low Voltage Directive) and 

subsequent modifications;

-

89/336 EEC

 of 3.5.89 (Electromagnetic 

Compatibility Directive) and subsequent 
modifications.

Please ensure that when the appliance is installed it is 
easily accessible for the engineer in the event of a 
breakdown.