Problem
Possible cause
Solution
The appliance is noisy.
The appliance is not supported
properly.
Check if the appliance stands stable
(all the four feet should be on the
floor).
The compressor operates
continually.
The temperature is not set correct-
ly.
Set a warmer temperature.
The lid has been opened too fre-
quently.
Do not leave the lid open longer than
necessary.
The lid is not closed properly.
Check if the lid closes well and the
gaskets are undamaged and clean.
Large quantities of food to be fro-
zen were put in at the same time.
Wait some hours and then check the
temperature again.
Food placed in the appliance was
too warm.
Allow food to cool to room tempera-
ture before storing.
The temperature of the room that
contains the appliance is too high
for efficient operation.
Try to reduce the temperature in the
room where the appliance stands.
The High temperature
alarm light is on.
It is too warm inside the freezer.
Refer to "High Temperature Alarm".
The cabinet has been recently
switched on and the temperature is
still too high.
Refer to "High Temperature Alarm".
There is too much frost
and ice.
Products are not wrapped properly.
Wrap the products better.
The lid is not shut properly or do
not close tightly.
Check if the lid closes well and the
gaskets are undamaged and clean.
The temperature is not set correct-
ly.
Set a warmer temperature.
The water drainage plug is not cor-
rectly positioned.
Position the water drainage plug in
the correct way.
The lid doesn't close com-
pletely.
There is excessive frost.
Eliminate excess frost.
The lid gaskets are dirty or sticky.
Clean the lid gaskets.
Food packages are blocking the lid.
Arrange the packages in the right
way, see the sticker in the appliance.
The lid is difficult to open.
The lid gaskets are dirty or sticky.
Clean the lid gaskets.
The valve is blocked.
Check the valve.
The lamp does not work.
The lamp is defective.
Refer to "Replacing the lamp".
It is too warm in the freez-
er.
The temperature is not set correct-
ly.
Set a lower temperature.
The lid does not close tightly or it is
not shut properly.
Check if the lid closes well and the
gasket is undamaged and clean.
Before freezing the appliance was
not precooled sufficiently.
Pre-cool the appliance for enough
time.
40
www.zanussi.com
Summary of Contents for ZFC321WA1
Page 43: ...43 www zanussi com ...
