•
Use only the fixing screws supplied with the appliance if not
supplied, use the screws recommended in the installation
instructions. Install the appliance in a safe and suitable place
that meets installation requirements.
•
WARNING: Failure to install the screws or fixing device in
accordance with these instructions may result in electrical
hazards.
•
Do not use adhesives to fix the appliance.
•
The minimum distance between the hob surface on which the
pans stand and the lower part of the appliance shall be at least
65 cm, unless otherwise specified in the installation instructions
for the appliance or hob.
•
The discharge of air must comply with local authorities
regulations.
•
Ensure good air ventilation in the room where the appliance is
installed to avoid the backflow of gases into the room from
appliances burning gas or other fuels, including open fires.
•
Make sure that the ventilation openings are not blocked and the
air collected by the appliance is not conveyed into a duct used
to exhaust smoke and steam from other appliances (central
heating systems, thermosiphons, water-heaters, etc.).
•
When the appliance operates with other appliances the
maximum vacuum generated in the room should not exceed
0.04 mbar.
•
Make sure not to cause damage to the mains cable. Contact
our Authorised Service Centre or an electrician to change a
damaged mains cable.
•
If the appliance is connected directly to the power supply, the
electrical installation must be equipped with an isolating device
that allows to disconnect the appliance from the mains at all
poles. Complete disconnection must comply with conditions
specified in the overvoltage category III. The means for
disconnection must be incorporated in the fixed wiring in
accordance with the wiring rules.
•
Do not flambé under the appliance.
•
Do not use to exhaust hazardous or explosive materials and
vapours.
3
Summary of Contents for ZFCT16X
Page 11: ......
