35
Technical data
Instructions for the Installer
Model
Gross capacity (l)
Net capacity (l)
Width (mm)
Height (mm)
Depth (mm)
Energy consumption (kWh/day)
(kWh/year)
Energy class, according to EU Standards
Freezing capacity (kg/24h)
Rising time (h)
Rated current (A)
Weight (kg)
ZFT 13 JD
115
98
595
850
635
0,504
184
A+
15
20
0,5
39
Transportation, unpacking
It is recommended to deliver the appliance in
original packaging, in vertical position
considering the protective warning on packaging.
After each transportation the appliance must not be
switched on for approx. 2 hours.
Unpack the appliance and check if there are
damages on it. Report possible damages
immediately to the place you bought it. In that case
retain packaging.
Cleaning
Remove every adhesive tape, which ensure the
parts not to move in the appliance.
Wash the inside of the appliance using lukewarm
water and mild detergent. Use soft cloth.
After cleaning wipe out the inside of the appliance.
Placement
The ambient temperature has an effect on the
energy consumption and proper operation of the
appliance. When placing, take into consideration that
it is practical to operate the appliance between
ambient temperature limits according to the climate
class that is given in the chart below and can be
found in the data label.
Class of climate
Ambient temperature
SN
+10 ... +32 °C
N
+16 ... +32 °C
ST
+18 ... + 38 °C
If the ambient temperature goes below the lower
data the temperature of the cooling compartment
can go beyond the prescribed temperature.
If the ambient temperature goes beyond the upper
data this means longer operating time of the
compressor, increasing temperature in the freezer or
increasing energy consumption.
When placing the appliance ensure that it stands
level. This can be achieved by two adjustable feet (1)
at the bottom in front. 1-1 piece of distance washers
(2) are accessories of the adjustable feet. If levelling
the appliance requires, these washers can be
removed.
Do not stand the appliance on a sunny place or close
to a radiator or cooker.
If it is unavoidable because of furnishing and the
appliance has to be stood near a cooker take these
minimum distances into consideration:
In case of gas or electric cooker 3 cm must be
left, when it is less put a 0,5 - 1 cm non-flam
insulation between the two appliances.
In case of oil or coal-fired stove the distance must
be 30 cm since they give off more heat.
The refrigerator is designed to operate when it is
totally pushed to the wall.
When placing the refrigerator keep minimal
distances recommended in figure.
A
: placing it under a wall-cupboard
B
: placing it freely
2
1
GB
