Zanussi ZFT11105XV, User Manual

Problem

Possible cause

Solution

The water drainage plug is not

correctly positioned.

Position the water drainage

plug in the correct way.

Food products are not wrap-

ped properly.

Wrap the food products better.

Temperature is set incorrectly.

Refer to "Operation" chapter.

Door is misaligned or interferes

with ventilation grill.

The appliance is not levelled.

Refer to "Levelling".

The temperature in the appli-

ance is too low/too high.

The temperature regulator is

not set correctly.

Set a higher/lower tempera-

ture.

The door is not closed correct-

ly.

Refer to "Closing the door".

The food products' tempera-

ture is too high.

Let the food products temper-

ature decrease to room tem-

perature before storage.

Many food products are stored

at the same time.

Store less food products at the

same time.

The thickness of the frost is

greater than 4-5 mm.

Defrost the appliance.

The door has been opened of-

ten.

Open the door only if necessa-

ry.

There is no cold air circulation

in the appliance.

Make sure that there is cold air

circulation in the appliance.

Door does not open easily.

You attempted to re-open the

door immediately after closing.

Wait a few seconds between

closing and re-opening of the

door.

If the advice does not lead to the

desired result, call the nearest

Authorized Service Centre.

CLOSING THE DOOR
1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective door

gaskets. Contact the Authorised Service

Centre.

INSTALLATION

WARNING! Refer to Safety chapters.

POSITIONING
Install the appliance in a dry, well ventilated indoors

where the ambient temperature corresponds to the

climate class indicated on the rating plate of the

appliance.

9