Zanussi ZFT11112WE, User Manual

Location

CAUTION!

It must be possible to disconnect

the appliance from the mains power

supply; the plug must therefore be

easily accessible after installation.

The appliance should be installed well away

from sources of heat such as radiators, boilers,

direct sunlight etc. Ensure that air can circulate

freely around the back of the cabinet. To ensure

best performance, if the appliance is positioned

below an overhanging wall unit, the minimum

distance between the top of the cabinet and the

wall unit must be at least 100 mm . Ideally,

however, the appliance should not be

positioned below overhanging wall units.

Accurate levelling is ensured by one or more

adjustable feet at the base of the cabinet.

min.

100 mm

15 mm

15 mm

Door reversibility

WARNING!

Before carrying out any operations,

remove the plug from the power

socket.

CAUTION!

To carry out the following

operations, we suggest that this be

made with another person that will

keep a firm hold on the doors of the

appliance during the operations.

1. Tilt back the appliance carefully so that the

compressor cannot touch the floor.

2. Unscrew the left foot.

3. Remove the lower door hinge by

unscrewing the 2 retaining screws.

4. Remove the hinge pin from the bottom of

the door.

5. Slot the hinge pin into the hole in the hinge

plate.

6. Take the door off.

7. Refit the upper hinge pin into the opposite

location.

8. Fit the door in place on the hinge pin.

9. Slot the hinge pin into the hole in the hinge

plate and relocate the hinge assembly to

the opposite location and refit using the

retaining screws.

10. Refit the bottom hinge plate assembly on

the opposite side, taking care that the edge

of the door is parallel with the side of the

cabinet.

11. Remove and install the handle (if foreseen)

on the opposite side.

www.zanussi.com

11