Zanussi ZFT11112WE, User Manual

CAUTION!

Reposition, level the appliance, wait

for at least four hours and then

connect it to the power socket.

Do a final check to make sure that:

• All screws are tightened.

• The magnetic seal adheres to the

cabinet.

• The door opens and closes

correctly.

If the ambient temperature is cold

(i.e. in Winter), the gasket may not fit

perfectly to the cabinet. In that case,

wait for the natural fitting of the

gasket. In case you do not want to

carry out the above mentioned

operations, contact the nearest After

Sales Service Force. The After Sales

Service specialist will carry out the

reversibility of the doors at your cost.

Electrical Connection

CAUTION!

Any electrical work required to install

this appliance should be carried out

by a qualified electrician or

competent person.

WARNING!

This appliance must be earthed. The

manufacturer declines any liability

should these safety measures not be

observed.

The wires in the mains lead are coloured in

accordance with the following code:

A

B

C

D

E

• A - green and yellow: Earth

• C - brown: Live

• D - blue: Neutral

As the colours of the wires in the mains lead of

this appliance may not correspond with the

coloured markings identifying the terminals in

your plug, proceed as follows:
1. Connect the wire coloured green and

yellow to the terminal marked either with the
letter “E“ or by the earth symbol   or

coloured green and yellow.

2. Connect the wire coloured blue to the

terminal either marked with the letter “N“ or

coloured black.

3. Connect the wire coloured brown to the

terminal either marked with the “L“ or

coloured red.

4. Check that no cut, or stray strands of wire is

present and the cord clamp (E) is secure

over the outer sheath. 

Make sure the electricity supply voltage is

the same as that indicated on the appliance

rating plate.

5. Switch on the appliance.

The appliance is supplied with a 13 amp fuse

(B). In the event of having to change the fuse in

the plug supplied, a 13 amp ASTA approved

(BS 1362) fuse must be used.

WARNING!

A cut off plug inserted into a 13 amp

socket is a serious safety (shock)

hazard. Ensure that it is disposed of

safely.

12

www.zanussi.com