Zanussi ZFT610W, User Manual

1. Remove the plug from

the power socket.

2. Tilt back the appliance

carefully so that the com-

pressor cannot touch the

floor.

3. Unscrew the adjustable

feet, situated on both sides

at the front.

4. Remove the lower door

hinge by unscrewing the 2

retaining screws.

5. Remove the hinge pin

from the bottom of the

door.

6. Slot the hinge pin into

the hole in the hinge plate.

7. Take the door off.

8. Refit the upper hinge pin

into the opposite location.

9. Fit the door in place on

the hinge pin.

10. Slot the hinge pin into

the hole in the hinge plate

and relocate the hinge as-

sembly to the opposite lo-

cation and refit using the

retaining screws.

11. Refit the bottom hinge

plate assembly on the op-

posite side, taking care that

the edge of the door is par-

allel with the side of the

cabinet.

12. Remove and install the
handle

1)

 on the opposite

side.

13. Reposition, level the

appliance, wait for at least

four hours and then con-

nect it to the power socket.

1) If foreseen

Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.

If the ambient temperature is cold (i.e. in Winter), the gas-

ket may not fit perfectly to the cabinet. In that case, wait

for the natural fitting of the gasket.

In case you do not want to carry out the above mentioned

operations, contact the nearest After Sales Service Force.

The After Sales Service specialist will carry out the rever-

sibility of the doors at your cost.

Electrical Connection

Caution! Any electrical work required to install this

appliance should be carried out by a qualified

electrician or competent person.

Warning! This appliance must be earthed.

The manufacturer declines any liability should these

safety measures not be observed.

1

2

3
4
5

Important! The wires in the mains lead are coloured in

accordance with the following code:

1

Green and Yellow:

Earth

3

Brown:

Live

11