Problem
Possible cause
Solution
Large quantities of food to be fro-
zen were put in at the same time
Insert smaller quantities of food to be
frozen at any one time.
Food placed in the appliance was
too warm
Allow food to cool to room tempera-
ture before storing.
Products to be frozen are placed
too closely to each other
Place the products in a way so that
cold air could circulate among them
It is too cold inside the
freezer
Temperature regulator may be set
incorrectly
Set a warmer temperature
The appliance does not
work at all. Neither cooling
nor lighting works
Plug is not connected to the mains
socket properly
Connect the mains plug properly
Power does not reach the appli-
ance
Try connecting another electrical de-
vice to the power outlet
The appliance is not switched on
Switch on the appliance
There is no voltage in the mains
socket (try to connect another ap-
pliance into it)
Call an electrician
The appliance does not
cool at all
Plug is not connected to the mains
socket properly
Connect the mains plug properly
There is no voltage in the mains
socket (try to connect another ap-
pliance into it)
Call an electrician
The appliance is not switched on
Switch on the appliance
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Technical data
Dimension
Height
850 mm
Width
550 mm
Depth
612 mm
Rising Time
22 h
Voltage
230-240 V
Frequency
50 Hz
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.
21
www.zanussi.com
Summary of Contents for ZFT711W
Page 49: ...49 www zanussi com ...
Page 50: ...50 www zanussi com ...
Page 51: ...51 www zanussi com ...