1. Remove the plug
from the power sock-
et.
2. Tilt back the appli-
ance carefully so that
the compressor can-
not touch the floor.
3. Unscrew the left
foot.
4. Remove the lower
door hinge by un-
screwing the 2 retain-
ing screws.
5. Remove the hinge
pin from the bottom of
the door.
6. Slot the hinge pin
into the hole in the
hinge plate.
7. Take the door off.
8. Refit the upper
hinge pin into the op-
posite location.
9. Fit the door in place
on the hinge pin.
10. Slot the hinge pin
into the hole in the
hinge plate and relo-
cate the hinge assem-
bly to the opposite lo-
cation and refit using
the retaining screws.
11. Refit the bottom
hinge plate assembly
on the opposite side,
taking care that the
edge of the door is
parallel with the side
of the cabinet.
12. Remove and install
the handle (if fore-
seen) on the opposite
side.
13. Reposition, level
the appliance, wait for
at least four hours and
then connect it to the
power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the cabi-
net. In that case, wait for the natural fitting of
the gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service
specialist will carry out the reversibility of the
doors at your cost.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate corre-
spond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact for
this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
Environmental concerns
The symbol on the product or on its
packaging indicates that this product may not
be treated as household waste. Instead it
should be taken to the appropriate collection
point for the recycling of electrical and
electronic equipment. By ensuring this product
23
www.zanussi.com
Summary of Contents for ZFT711W
Page 49: ...49 www zanussi com ...
Page 50: ...50 www zanussi com ...
Page 51: ...51 www zanussi com ...
