Zanussi ZFT916Y, User Manual

DAILY USE

USING THE HOOD
Check the recommended speed according to the

table below.

While heating up food, cooking with covered pots.

While cooking with covered pots on multiple cooking zones or burners, gentle frying.

While boiling and frying big quantities of food without a lid, cooking on multiple cooking

zones or burners.
While boiling and frying big quantities of food without a lid, big humidity.

Refreshes the air in kitchen after cooking at a very low noise level. It can be activated

and de-activated by touching the symbol. The function turns off automatically after 60

minutes. Use after cooking only.

It is recommended to leave the hood

operating for approximately 15 minutes

after cooking.

The control Panel is a sensor field.

Touch the symbols for 1 second to

activate the functions.

To operate the hood:

1. Turn on the appliance by pressing the 

symbol.

You can now activate the functions.

2. To activate the function touch the symbol.

The hoods light works independently

to other hood functions. To illuminate
the cooking surface touch  .

To turn off the appliance press the   symbol

again.

HOB²HOOD FUNCTION 
It is an automatic function which connects the hob

with a hood. Both the hob and the hood have an

infrared signal communicator. Speed of the fan is

defined automatically on basis of mode setting and

temperature of the hottest cookware on the hob.

You can also operate the fan using the hob

manually. The function can be activated from panel

of the hob.

For more information how to use the

function refer to the hob user manual.

ACTIVATING MAXIMUM MOTOR SPEED

When you touch   , the Maximum Motor Speed

starts to operate for 8 minutes. After that time, the

appliance returns to its previous speed settings.

When the function is turned on,
additional touch on   does not have

any effects.

FILTER NOTIFICATION
Filter alarm reminds to change or clean the charcoal

filter and clean the grease filter. The filter indicator

 is turned on for 30 seconds if the grease filter

must be cleaned. The filter indicator   flashes for

30 seconds if the charcoal filter must be replaced

or cleaned.

Refer to cleaning the grease filter in

care and cleaning chapter.

Refer to cleaning the charcoal filter or

replacing the charcoal filter in care and

cleaning chapter.

To reset the function touch   for 3 seconds.
To activate or deactivate function:

1. Switch on the control panel.

2. Make sure that the icons are turned white.
3. To activate function touch   for 3 seconds.

If the function is activated, the filter icon   flashes

five times.

4. To deactivate function touch   for 3 seconds.

3