Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.
The appliance must be earthed. The power sup-
ply cable plug is provided with a contact for this
purpose. If the domestic power supply socket is
not earthed, connect the appliance to a sepa-
rate earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
Levelling
When placing the appliance ensure that it
stands level. This can be achieved by two ad-
justable feet at the bottom in front.
Door reversibility
Important!
To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door, do
these steps:
• Remove the plug from the power socket.
• Tilt back the appliance carefully so that the
compressor does not touch the floor.
1. Remove the plinth.
2. Unscrew and remove the lower hinges.
3. Remove the door.
4. Unscrew the upper pin and screw it on the
opposite side.
5. Refit the door.
6. Make sure the edge of the door is parallel
with the edge of the top.
2
1
7. Unscrew the pin (A) and screw it on the op-
posite side.
8. Remove the cap (B) and position it on the
opposite side.
9. Screw the lower hinges.
10. Refit the plinth.
A
B
11. Stand the appliance upright.
12. Fit the handle on the opposite side and put
the plastic caps (contained in the instructions
bag) in the free holes.
21
www.zanussi.com
Summary of Contents for ZFU25200
Page 46: ...46 www zanussi com ...
Page 47: ...47 www zanussi com ...
