To change the opening direction of the door,
do these steps:
• Remove the plug from the power socket.
• Tilt back the appliance carefully so that the
compressor cannot touch the floor.
• Remove the plinth (1).
• Remove the cap (2) and position it on the
opposite side.
• Unscrew the hinge (3) and remove the door.
• Unscrew the lower pin and the washers (3)
• Position the pin and the washers (6) on the
opposite side (7).
• Unscrew the other hinge (5)
1
2
3
8
6
7
• Unscrew the upper pin (4) and screw it on
the opposite side. (5)
• Refit the door.
• Refit and screw both lower hinges.
• Refit the plinth (8).
5
4
• Stand the appliance upright.
• Unscrew the handle (1) and fix it on the op-
posite side (2).
• Re-insert the cover pins (3) on the opposite
side.
3
1
2
Do a final check to make sure that:
• All screws are tightened.
23
www.zanussi.com
Summary of Contents for ZFU428MW
Page 51: ...51 www zanussi com ...