sponds to the climate class indicated on the
rating plate of the appliance:
Climate
class
Ambient temperature
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Rear spacers
In the bag with the documentation, there are
two spacers which must be fitted as shown in
the figure.
Using fine strokes of hammer put them in their
place.
Location
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circulate
freely around the back of the cabinet. To ensure
best performance, if the appliance is positioned
below an overhanging wall unit, the minimum
distance between the top of the cabinet and
the wall unit must be at least 100 mm .
Ideally, however, the appliance should not be
positioned below overhanging wall units. Accu-
rate levelling is ensured by one or more adjust-
able feet at the base of the cabinet.
If the cabinet is placed in a corner and the side
with the hinges facing the wall, the distance be-
tween the wall and the cabinet must be at least
10 mm to allow the door to open enough so
that the shelves can be removed.
Warning!
It must be possible to
disconnect the appliance from the mains
power supply; the plug must therefore be easily
accessible after installation.
~10 cm
A
B
~2,5 cm
~2,5 cm
Door reversibility
Important!
To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door,
do these steps:
30
www.zanussi.com
Summary of Contents for ZFX405W
Page 55: ...55 www zanussi com ...
