1
2
1. Remove the plug
from the power sock-
et.
2. Remove the top
hinge cover.
3. Unscrew the 2 re-
taining screws, and re-
move the hinge from
the appliance.
4. Take the door off.
5. Remove the screw
fixing the lower door
hinge and the other
screw fixing the lower
door hinge and the
foot. Then remove the
door hinge and the
foot as shown in the
Figure.
6. Loosen the screw
fixing the foot opposite
the lower door hinge
in order to remove the
foot.
7. Fix the door hinge
and the corresponding
foot on the opposite
side and then the oth-
er loosened foot at the
former place of the
door hinge as shown
in the Figure.
8.
Please make sure
to place the lower
foot below the door
hinge. The lower
foot is recognizable
by its 4 ribs on the
outer surface.
9. Fix the door onto
the lower hinge pin.
10. To fit top door
hinge, remove the
plastic blanking plugs
carefully, and refit
them in the holes left
by the hinge retaining
screws.
11. Refit the top hinge
using the 2 retaining
screws, taking care
that the edge of the
door is parallel with
side of the cabinet.
12. Replace the hinge
cover.
13. Relocate the han-
dle and the plastic
plugs to the opposite
side.
14. Level the appli-
ance, wait for at least
four hours and then
connect it to the pow-
er socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the cabi-
net. In that case, wait for the natural fitting of
the gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service
specialist will carry out the reversibility of the
doors at your cost.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate corre-
spond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact for
this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
31
www.zanussi.com
Summary of Contents for ZFX405W
Page 55: ...55 www zanussi com ...