Installation
Warning!
Refer to the Safety chapters.
Warning!
The following instructions about
installation, connection and maintenance
must be carried out by qualified personnel in
compliance with standards and local
regulations in force.
Important safety requirements
This hob must be installed in accordance with
the Gas Safety (Installation and Use) Regula-
tions (Current Edition) and the IEE Wiring Reg-
ulations (Current Edition).
For appliances installed in the Republic of Ire-
land please refer to NSAI- Domestic Gas In-
stallation I.S. 813 Current Editions and the ET-
CI Rules for Electrical Installations.
Provision for ventilation
Detailed recommendations are contained in the
following British Standards Codes Of Practice:
B.S. 6172/ B.S. 5440, Par. 2 and B.S. 6891
Current Editions.
The hob should not be installed in a bed sitting
room with a volume of less than 20 m³. If it is
installed in a room of volume less than 5 m³ an
air vent of effective area of 100 cm² is required.
If it is installed in a room of volume between 5
m³ and 10 m³ an air vent of effective area of 50
cm² is required, while if the volume exceeds 11
m³ no air vent is required.
However, if the room has a door which opens
directly to the outside no air vent is required
even if the volume is between 5 m³ and 11 m³.
If there are other fuel burning appliances in the
same room, B.S. 5440 Part 2 Current Edition,
should be consulted to determine the requisite
air vent requirements.
For appliances installed in the Republic of Ire-
land please refer to the NSAI- Domestic Gas
Installation I.S. 813 Current Editions Table
Four.
Location
The hob may be located in a kitchen, a kitchen/
diner or bed sitting room (with a volume greater
than 20 m³), but not in a bathroom or shower
room.
The minimum distance combustible material
can be fitted above the hob in line with the
edges of the hob is 400 mm. If it is fitted below
400 mm a space of 50 mm must be allowed
from the edges of the hob.
For appliances installed in the Republic of Ire-
land please refer to NSAI- Domestic Gas In-
stallation I.S 813 Current Edition Section 7-
Permitted Locations of Appliance.
Gas Connection
Warning!
Any gas installation must be
carried out by a GAS SAFE REGISTER
installer.
Make sure that, once the hob is installed, it is
easily accessible for the engineer in the event
of a breakdown.
The manufacturer will not accept liability,
should the above instructions or any of the oth-
er safety instructions incorporated in this in-
struction booklet be ignored.
On the end of the shaft, which includes the G
1/2" threaded elbow, adjustment is fixed so that
the washer is fitted between the components
as shown in the diagram. Screw the parts to-
gether without using excessive force.
A
B C
A) End of shaft with nut
B) Washer
C) Elbow
Connection to the gas supply should be with
either rigid or semi-rigid pipe, i.e. steel or cop-
per.
The connection should be suitable for connect-
ing to R 1/2 (1/2 BSP male thread).
9
www.zanussi.com
Summary of Contents for ZGL642T
Page 1: ...EN User manual Hob ZGL642T IE GB ...
Page 15: ...15 www zanussi com ...
