15
2 - Fitting the fixing elements
a) Insert the rawl plugs provided into holes 1 and 2.
b) Fit the eye bolts O (fig. 6).
c) Fix the wall bracket S in hole 2 using the screw V provided (fig. 7).
3 - Fitting the hood canopy
C
to the
wall
a) Remove the metal grease filters
and the activated charcoal filter,
if there is any (see the paragraph on
Maintenance).
b) Fit the support rod
B
using the
two screws
K
(3,5x9,5) provided
(
fig. 8
).
c) Hook the hood canopy
C
to the eye bolts
O
fixed in holes
1
(
fig. 9
).
d) Adjust the support rod
B
so that it pushes
against the wall (
fig. 10
).
e) Adjusting position (
fig. 11
). There are two
adjustable hooks at the rear of the hood,
which can be used to adjust its position as
follows:
- Turn the screws
L
until the position of
screws
N
coincides with the lower access
holes.
- Turn the screws
N
to adjust the vertical and
horizontal position of the hood.
- Lock the screws L to fasten the hood
against the wall.
- Insert the plugs
T
provided in the holes
giving access to screws
N
.
A08_11
L
N
L
N
L
N
T
T
11
1
O
A08_06
6
L = 44 mm
V
S
2
A08_07
7
A03_08
K
B
8
O
A03_09
O
O
9
B
A03_10
10
