19
GB
Flue assembly - Mounting the hood body
ELECTRICAL CONNECTION
• Position the upper chimney section and fix the
upper part to the frame using the 2 screws 12c
provided.
• Similarly, position the lower chimney section
without fixing it, ensuring that the outlet from
connector 15 is in line with the chimney intake.
• The air outlet directional grill 8 must be fitted
after the installation of the chimney.
Before fixing the hood body to the frame:
• remove the grease filters from the hood body;
• remove the activated carbon odour filters, if
fitted.
• from below, use the 4 screws 12f provided to fix
the hood body to the frame.
• For the recirculation version, locate the
directional grill 8 in its housing. Ensure that it is
inserted correctly in connector 15.
• Connect the hood to the mains through a two-
pole switch having a contact gap of at least 3 mm.
• Connect the control connector Cmd.
• Place the connector in the junction box 24 and
close it using the 4 screws 12e provided.
• Fix the junction box to the hood body using the 2
screws 12c provided.
• For the recirculation version, fit the activated
carbon odour filter.
• Replace the grease filters.
12f
8b
24
12e
Cmd
12c
