Zanussi ZHC945, Instruction Booklet

10

SOMETHING NOT WORKING

SERVICE AND SPARE PARTS

If, having followed these instructions carefully, your cooker hood fails to work properly please carry out
the following checks.

    Symptom

     The cooker hood will not start

     The cooker hood is not working effectively

     The cooker hood has switched off during opera-

tion

If after all these checks, the fault persists,
contact your local Service Force Centre,
quoting the model and serial number.

Please note that it will be necessary to
provide proof of purchase for any
in-guarantee service calls.

    Solution

     •   Check the hood is connected to the electricity 

supply.

     •   Make sure the switch is in the ‘ON’ position.

     •   The fan speed is set high enough for the task
     •   The grease 

fi

 lter is clean.

     •   The kitchen is adequately vented to allow the 

entry of fresh air.

     •   If set up for recirculation, check that the charcoal 

fi

 lter is still effective.

     •   If set up for extraction, check that the ducting and 

outlets are not blocked.

     •   The safety cut-out device has been tripped.
     •   Tum off the hob and then wait for the device to 

reset.

In-guarantee customers should ensure
that the above checks have been made as
the engineer will make a charge if the fault
is not a mechanical or electrical
breakdown.

If you require an engineer or spare parts
contact your local Service Force Centre by
telephoning:

08705 929929

Your telephone call will be routed to your local
Service Force Centre. For the address of your 
local Service Force Centre and further information 
about Service Force, please visit the website at 
www.serviceforce.co.uk

For general assistance with your appliance or
for further information on Zanussi products
please contact our Customer Care Department.

Customer Care Department
Major Appliances
Zanussi
Addington Way
Luton
Bedfordshire
LU4 9QQ
Tel: 08705 727 727 *

*    calls to this number may be recorded for training 

purposes.