Zanussi ZHC945, Instruction Booklet

15

Fitting the Wall Brackets

Wall marking:

•  Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area 

in which the hood will be installed.

•  Draw a horizontal line at 650 mm above the hob.
• Place bracket 

7.2.1

 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning the centre 

(notch) with the vertical reference line.

•  Mark the wall at the centres of the holes in the bracket.
•  Place bracket 

7.2.1 

on the wall as shown at X mm below the 

fi

 rst bracket (X = height of the upper

  chimney section supplied), aligning the centre (notch) with the vertical line.
•  Mark the wall at the centres of the holes in the bracket.
•  Mark a reference point as indicated at 116 mm from the vertical reference line and 306 mm above the horizontal 

reference line.

•  Repeat this operation on the other side.
•  Drill ø 8 mm holes at all the centre points marked.
•  Insert the wall plugs (not supplied) in the holes.
•  Fix the lower bracket 

7.2.1

  using the two screws (not supplied).

•  Fix the upper bracket 

7.2.1

 and the air outlet connection support 

7.3

 together using the two screws (not sup-

plied). 

•  Insert the two screws (not supplied) in the hood body 

fi

 xing holes, leaving a gap of 5-6 mm between the wall 

and the head of the screw.

Note:  If the hood is to be installed onto a hollow construction or plaster or partition board wall then special 

fi

 xing screws will be required (not supplied).

INSTALLING THE COOKER HOOD