Zanussi ZHC945, Instruction Booklet

9

          Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply.
 
 

Charcoal Filters

In the recirculation mode the charcoal 

fi

 lters absorb smells and unwanted odours.

Enabling the alarm signal

•  In Recirculation version Hoods, the Filter saturation alarm can be enabled on installation or at a later date.
•  Turn the Lights and the suction Motor off.
•  Disconnect the Hood using the Main switch or the double-pole switch on the mains power supply.
•  Restore the connection by pressing and holding 

T1

.

•  Release the button.  All 

fi

 ve LEDs are turned on

•  Within 3 seconds press 

T1 

until LEDs  

T1 

and 

T4 

fl

 ash in con

fi

 rmation:

 • 

LED 

fl

 ashes twice - Activated charcoal 

fi

 lter saturation alarm 

ENABLED

 • 

LED 

fl

 ashes once - Activated charcoal 

fi

 lter saturation alarm 

DISABLED

The 

fi

 lter is not washable and cannot be regenerated. It must be replaced when led 

S1 

fl

 ashes or at least every 

4 months. The alarm signal will only light up when the extractor motor is switched on.

To Remove/Replace the Charcoal Filters

•    Remove the metal grease 

fi

 lters

•    Remove the saturated activated carbon 

fi

 lter by

     releasing the 

fi

 xing hooks

•    Fit the new 

fi

 lter by hooking it into its seating

•    Replace the metal grease 

fi

 lters.

This appliance can be a possible 

fi

 re 

hazard if the grease and charcoal 

fi

 lters

are not cleaned and replaced as recommended.

Alarm signal reset

•  Switch off the lights and extractor motor.
• Press button 

T3 

for at least 3 seconds, until the leds start to 

fl

 ash.

Changing the halogen light

•  Remove the snap-on lamp cover by levering it from under 

the metal ring, supporting it with one hand.

•  Remove the halogen lamp from the lamp holder by pulling 

gently.

•  Replace the lamp with a new one of the same type, making 

sure that you insert the two pins properly into the housings 
on the lamp holder.

•  Replace the snap-on lamp cover.

Replacement 

fi

 lters and halogen light can be obtained from your local Service Force Centre.

MAINTENANCE AND CLEANING