13
GB
INSTALLATION
Drilling the Support surface and Fitting the Hood
SCREW FITTING
SNAP-ON FITTING
• The hood support surface must be 135 mm above
the bottom surface of the wall units.
• Drill the support with a ø 4.5 mm drill bit, using
the drilling template provided.
• Cut a hole ø 125 mm in size on the support
surface, using the drilling template provided.
• Fix using the 4 screws 12a (4,2 x 44,4) provided.
• The hood can be installed either directly on the
bottom surface of the wall units (min. 650 mm
above the hob) using snap-on side supports.
• Cut a fitted opening in the bottom surface of the
wall unit, as shown.
• Insert the hood until the side supports snap into
place.
• Lock in position by tightening the screws Vf
from underneath the hood.
Hood Type
45
50
55
60
70
80
90
L1
352
402
452
502
602
702
802
12a
135
125
125
15
264
L1
Vf
