Zanussi ZHT911X, User Manual

2

www.zanussi.com

 SAFETY  INFORMATION

For your own safety and to 

ensure proper operation of 

the appliance, please read this 

manual carefully before installation 

and operation. Keep these instruc-

tions together with the appliance, 

even if it is sold or transferred to 

third parties. It is important that 

users know all the ap

pliance’s 

operating and safety characteris-

tics.

  The cables must be connected 

by a trained technician.

• The manufacturer shall not be con-

sidered responsible for any injury 

or damage caused by improper 

installation or use. 

• The minimum safety distance 

between the hob and the suction 

hood is 650 mm (some models 

may be fitted at a lower height; 

please see the paragraph relat-

ing to working dimensions and 

installation).

• If the instructions for installation 

of the gas hob specify a distance 

greater than the one indicated, this 

must be taken into account. 

• Check that the mains power 

supply corresponds to the one 

indicated on the data plate affixed 

inside the hood.

• The cut-out devices must be in-

stalled in the fixed system accord

-

ing to wiring system regulations.

• For Class I appliances, check 

that the do

mestic power supply 

is adequately earthed.

• 

Connect the hood to the flue using 

a pipe with a minimum diameter of 

120 mm. The fumes must travel 

the shortest distance possible.

• All the air venting regulations must 

be complied with.

• Do not connect the ducting hood 

to flues that also carry combustion 

fumes (e.g. boilers, chimneys, 

etc.).

• If the hood is used in combination 

with non electric appliances (e.g. 

gas appliances), a sufficient level 

of ventilation must be guaran-

teed in the room to prevent any 

exhaust backflow. If the kitchen 

hood is used in combination with 

appliances that are not electrically 

powered, the negative pressure in 

the room must not exceed 0.04 

mbar to avoid any risk of the fumes 

being sucked back into the room 

by the hood.

• 

The  air  must  not  be  extracted 

through a flue that is also used as 

an exhaust flue for fumes from gas 

or other fuel powered combustion 

devices.

• If it is damaged, the power cable 

must be replaced by the manu-

facturer or by a service technician.

• Connect the plug to a socket that 

complies with current regulations 

and is in an accessible position.

• As regards the technical and safety 

measures to be taken for exhaust

-

ing of fumes, it is important that the 

EN