Zanussi ZI 1450, Instruction Booklet

CUSTOMER SERVICE AND
SPARE PARTS

If the appliance is not functioning properly, check that:

the plug is firmly in the wall socket and the mains
power switch is on;

there is an electricity supply (find out by plugging in
another appliance);

the thermostat knob is in the correct position.

If your appliance is still not working properly after
making the above checks, contact the nearest service
centre.

To obtain fast service, it is essential that when
you apply for it you specify the model and serial
number of your appliance which can be found on
the guarantee certificate or on the rating plate
located inside the appliance, on the bottom left-
hand side.

The technical data is indicated in the rating plate on the left side inside the appliance.

TECHNICAL SPECIFICATIONS

INSTALLATION

lf this appliance featuring magnetic door seals is
to replace an older appliance having a spring lock
(latch) on the door or lid, be sure to make that
spring lock unusable before you discard the old
appliance. This will prevent it from becoming a
death-trap for a child.

Positioning

The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Best performance is obtained with ambient
temperature b18°C and +43°C (class T);
+18°C and +38°C (class ST); +16°C and +32°C
(class N); +10°C and +32°C (class SN).
The class of your appliance is shown on its rating
plate.

For building-in and door reversibility refer to the
relevant instructions.

Electrical connection

Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.

8

Important

The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not
earthed. connect the appliance to a separate
earth in compliance with current regulations,
consulting a specialist technician.

The Manufacturer declines all responsibility if the
above safety precautions are not observed.

Attention!
It must be possible to disconnect the appliance

from the mains power supply; the plug must
therefore be easily accessible after installation.

This appliance complies with EEC directive
number, 87/308 of 2/6/87 relative to radio
interference suppression.

This appliance complies with the following
E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage Directive) and

subsequent modifications;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent
modifications.