15
Position the runners (H) at the top and bottom of
the inside of the kitchen unit as shown in Fig. 8 and
mark the position of the external holes.
After preparing the holes, screw the runners to the
kitchen unit door using 3.5x16 mm screws.
Fig. 8
Open both the appliance door and that of the
kitchen unit to approx. 90
°
.
Place the little plates over the runners. Hold the
doors of the appliance and the unit together and
mark the holes.
Fig. 9
D094
20mm
H
8mm
PR34
Remove the little plates and make the holes with a
diam. of 2 mm. Replace the little plates over the
runners and screw in the screws provided
(3.5x16 mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted
holes.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
Fig. 10
The upper compartment can be opened by means of
the sliding system illustrated in the previous point,
or else by attaching on the door the handle which is
supplied as an accessory (see figure).
Fig. 10a
PR35
D029
