29
Building-in
This appliance has been designed to be built
into the kitchen furniture. The recess should
have the dimensions shown in picture
A
.
When installing the
appliance into the
kitchen furniture
ensure, if possible, the
hoses are placed in
either of the two
recesses on the back
of the appliance. This
will help to prevent the hoses from becoming
kinked or trapped.
Preparation and assembly of the door
The machine is originally pre-arranged for the
assembly of a door opening from right to left.
In this case it is
sufficient to screw in
the hinges (1) and the
counter-magnet (6)
provided with the
appliance, at the right
level (Fig.
B
).
a) Door
The dimensions of the door should be:
- width
595-598 mm
- thickness 16-22 mm
The height (C-Fig.
C
) depends on the height of
the adjacent furniture's base.
b) Hinges
To mount the hinges it
is necessary to drill
two holes (dia. 35 mm,
depth 12.5-14 mm
depending on the
depth of door furniture)
on the inner side of the
door. The distance between the holes hobs fix-
ing centres must be 416 mm.
35 Ø 12.5-14 depth
16-22
B
C
22+1,5
595-598
41
6
C
4
1 2
3
6
1
2
3
5
7
8
B
820 min
600 min.
600
596
41
6
176
,5
81
8
541
195
490
160
120
90
8
515
165
A
600
The distance (B) from upper edge of the door
to the centre of the hole depends on the adja-
cent furniture's dimensions.
The required dimensions are given in the pic-
ture
C
. The hinges will be fixed to the door by
means of screws for wood (2-Fig.
B
) supplied
with the appliance.
c) Mounting the door
Fix the hinges (1) to the machine by means of
the M 5x15 screws (3-Fig.
B
). The hinges can
be adjusted to compensate for possible
uneven thickness of the door.
To align the door perfectly it is necessary to
loosen the screw (3-Fig.
B
), adjust the door
and tighten the screw again.
d) Counter-magnet (6)
The appliance is pre-arranged for a magnetic
closure of the door. To enable a correct opera-
tion of this device, it is necessary to screw the
counter-magnet (6) (steel disk + rubber ring)
into the inner side of the door.
Its position must corre-
spond to the magnet
(4) on the appliance
(see picture
D
). If the
door has to be opened
from left to right, invert
the position of the
plates (7), the magnet
(4) and the plate (5) (Fig.
B
and
E
). Mount the
counter-magnet (6) and the hinges (1) as
previously described.
4
6
5
1
2
3
7
8
E
6
4
8
D
132956230.qxd 26/01/2009 8.32 Pagina 29
