Zanussi ZKN20/10L, User Manual

21

Installation

Fig. 1

Fig. 3

Fig. 2

Fig. 4

Positioning

• Place the refrigerator away from direct sunlight and

heat sources.

• Take off at least 50 mm. free over the appliance.
• Never put something on the ventilator of the applian-

ce. (see fig. 1).

• Make sure the refrigerator is accurately levelled tur-

ning the adjustable feet on the front, in order to avoid
vibrations and noises and to make sure that the doors
shut properly (see fig. 2).

• Before placing the plinth cover, pull out the fixing

part of doors used only for security during transport
(see fig. 3).

• With the freezer door wide-open, assemble the socle

provided inside the appliance, following the instruc-
tions stuck on it.

• Remove the shelves transport fastening red pieces

by sliding them (see fig. 4).

• The appliance should not be located in places with

maximum temperatures more than:
+ 32°C for N/SN Class (classification on rating
plate).
+ 43°C for T/ST Class (classification on rating
plate). 
If the temperatures are higher than those mentioned
above, the functioning and the safety of the applian-
ce could be affected.

Cleaning the interior

• Do not use alcohol or any cleaning produts contai-

ning alcohol because they could damage the plastic
parts of the appliance.

• Before using the appliance for the first time, wash

the interior with luke warm water and a neutral soap.
This will help to remove the typical smell of a new
fridge/freezer. Afterwards dry thoroughly.

• Do not use detergents or abrasive powders as these

will damage the finish.

• Remove security elements used for transportation.

Electrical connection

m

Before plugging the appliance into a socket make
sure that the voltage and frequency shown on the
rating plate correspond to your home supply. (see
fig. 5).
It is essential that the appliance should be properly
earthed.

m

For this purpose the supply cable plug incorporates
a special earth contact. If the sockets of your domes-
tic wiring system are not earthed, have the appliance
connected to a separate earth wire in accordance
with existing safety regulations.