1. Remove any promotional label from the door. The
plastic film inside the door of the oven should not
be removed.
2. Install the oven on a flat, level surface at least 85
cm above ground. The surface must be strong
enough to safely bear the weight (15 kg) of the
oven, and the contents. To avoid the possibility of
causing vibration or noise the oven must be in a
stable position.
3. Keep the oven away from any direct source of heat
or steam, and water. Exposure to heat and water
can lower oven efficiency and lead to malfunctio-
ning, so be sure to install the oven away from heat
and water sources.
4. Do not block air vents nor place any articles on the
top of the oven. If air vents are blocked during
operation, the oven may overheat, and this may
lead to malfunctioning. Hot air escapes from the
vents, so be sure not to obstruct it or let curtains
come between the oven and the rear wall.
In order to ensure that air circulates freely around
the oven, leave a minimum of 5 cm between the
sides of the oven and any objects, 14 cm above and
10 cm behind the oven.
5. Make sure the electrical plug will be accessible
after installation.
6. Place the oven as far away from radios and TV’s as
possible. This oven does conform to EEC require-
ments* of radio interference suppression, but some
interference may occur if it is placed too close to a
radio or TV, so keep them as far apart as possible.
* This appliance conforms to the requirements of
EEC Radio Interference Directive 87/308/EEC.
Check the power voltage. If there is a permanent
undervoltage, consult your electrical installer.
Your installation must be protected by a 10 Amp
thermal fuse. In your electrical installation, provide a
device that is accessible to the installer, capable of
separating the appliance from the mains power and
whose contact opening is at least 3mm at all the
poles.
The oven is delivered with the power cord and a plug
for 230 V, 50Hz, earthed socket outlet.
Earth protection minimizes the risks should a short
circuit occur. Check to ensure the voltage of the oven
matches the supply.
N.B. If the oven is connected to the socket via an
extension cord, make sure the cord is earthed.
WARNING! This appliance must not be used on a
nonearth protected power supply. Contact an electri-
cian if you are uncertain regarding electrical connec-
tion of the oven or provision of earth protection of
the supply. If this appliance is fitted with a non-rewi-
rable plug for which your socket is unsuitable, the
plug should be cut off and the appropriate plug fitted.
If it is necessary to change the fuse in a nonrewirable
plug, the fuse cover must be refitted. If the fuse cover
is lost or damaged, the plug must not be used until a
replacement is obtained. Never operate the oven if
the supply cord and/or its plug are damaged. In case
of damage, call in a specialised technician trained by
the manufac-turer.
29
Unpacking
N.B.
When you unpack the oven, check that the pro-
duct is free from damage. Damage or any missing
parts must be reported immediately to the retailer. The
oven, parts of the oven or the accessories may be
wrapped by a protection foil. If so, you must remove
this foil before using the oven. Do not leave packing
material so that small children can play with it. This
can be hazardous.
ZMB 17 M
t
Installation
Installation
Connecting to the mains
