Zanussi ZMC19M, User Manual

ZMC19ML                                                                                                           

                             English

8

1. Remove any promotion label from the door. 
 
2. The oven should be installed on a flat, level  
    surface. The surface must be strong enough to  
    safely bear the weight (12 kg) of the oven, and  
    the contents. To avoid the possibility of causing  
    vibration or noise the oven must be in a stable  
    position. 
 
3. Keep the oven away from heat and water.  
    Exposure to heat and water can lower oven  
    efficiency and lead to malfunctioning, so be sure to  
    install the oven away from heat and water sources. 
 
4. Do not block air vents on the top and the sides of  
    the cabinet and also do not place any articles on  
    the top of the oven. If air vents are blocked during  
    operation, the oven may overheat, and this may  
    lead to malfunctioning. Hot air escapes from the  
    vents, so be sure not to obstruct it or let curtains  
    come between the oven and the rear wall.  
 
5. Place the oven as far away from radios and TV’s  
    as possible. This oven does conform to EEC  
    requirements of radio interference suppression, but  
    some interference may occur if it is placed too  
    close to a radio or TV, so keep them as far apart  
    as possible. 
 
6. If positioned in a corner, leave a gap of at least  
    10 cm from the walls and 10 cm above the  
    microwave. 

 
IMPORTANT! 

The oven can be placed almost 

anywhere in the kitchen. Make sure the oven is 
placed on a flat, level surface and that vents as 
well as the surface underneath the oven are not 
blocked (for sufficient ventilation). 
 
 
 
 
 
 
 

Connecting to the mains 

 
The oven is delivered with the power cord and a plug 
for 230V, 50Hz, earthed socket outlet.  
Earth protection minimises the risks should a short 
circuit occur. Check to ensure the voltage of the oven 
matches the supply. 
 
N.B. If the oven is connected to the socket via an 
extension cord, make sure the cord is earthed. 

ã

This appliance must not be used on a non-
earth protected power supply. Contact an 
electrician if you are uncertain regarding 

electrical connection of the oven or 
provision of earth protection of the 
supply. 

ã

This appliance must be earthed. If this 
appliance is fitted with a non-rewireable 
plug for which your socket is unsuitable, it 

must be replaced by the manufacturer, its 
service agent or similarly qualified persons 
in order to avoid a hazard. 

ã

If the supply cord is damaged, it must be 
replaced by the manufacturer, its service 
agent or similarly qualified persons in 

order to avoid a hazard. 

Installation.