necessary to allow door opening to the minimum
angle permitting removal of all internal equipment
LOCATION
To ensure appliance's best functionality, you should
not install the appliance in the nearby of the heat
source (oven, stoves, radiators, cookers or hobs) or
in a place with direct sunlight. Make sure that air
can circulate freely around the back of the cabinet.
This appliance should be installed in a dry, well
ventilated indoor position.
This appliance is intended to be used at ambient
temperature ranging from 10°C to 43°C.
The correct operation of the appliance
can only be guaranteed within the
specified temperature range.
If you have any doubts regarding
where to install the appliance, please
turn to the vendor, to our customer
service or to the nearest Authorised
Service Centre.
It must be possible to disconnect the
appliance from the mains power
supply. The plug must therefore be
easily accessible after installation.
ELECTRICAL CONNECTION
• Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.
• The appliance must be earthed. The power
supply cable plug is provided with a contact for
this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
• The manufacturer declines all responsibility if
the above safety precautions are not observed.
• This appliance complies with the E.E.C.
Directives.
VENTILATION REQUIREMENTS
The airflow behind the appliance must be sufficient.
5 cm
min.
200 cm
2
min.
200 cm
2
CAUTION! Refer to the installation
instructions for the installation.
DOOR REVERSIBILITY
Please refer to the separate document with
instructions on installation and door reversal.
CAUTION! At every stage of reversing
the door protect the floor from
scratching with a durable material.
CONTROL PANEL
1
2
4
3
2
5
2
4
2
3
2
1
7
6
1. Fridge temperature indicator LED
2. Freezer temperature indicator LED
3. FastFreeze indicator
4. Fridge compartment indicator
5. Freezer compartment indicator
6. ON/OFF button
Compartment selection button
7. FastFreeze button
Temperature regulator
SWITCHING ON
1. Insert the plug into the wall socket.
2. Touch the ON/OFF button (6) if all LED
indicators are off.
7