Zanussi ZNNN18ES3, User Manual

Problem

Possible cause

Solution

Acoustic or visual alarm is on.

The cabinet has been recently

switched on.

Refer to "High temperature

alarm" or "Door open alarm".

The temperature in the appli-

ance is too high.

Refer to "High temperature

alarm" or "Door open alarm".

The door is left open.

Close the door.

The compressor operates con-

tinually.

Temperature is set incorrectly.

Refer to "Control panel" chap-

ter.

Many food products were put

in at the same time.

Wait a few hours and then

check the temperature again.

The room temperature is too

high.

Refer to "Installation" chapter.

Food products placed in the

appliance were too warm.

Allow food products to cool to

room temperature before stor-

ing.

The door is not closed correct-

ly.

Refer to "Closing the door"

section.

The FastFreeze function is

switched on.

Refer to "FastFreeze function"

section.

The compressor does not start

immediately after pressing the

"FastFreeze", or after changing

the temperature.

The compressor starts after a

period of time.

This is normal, no error has oc-

curred.

Door is misaligned or interferes

with ventilation grill.

The appliance is not levelled.

Refer to installation instruc-

tions.

Door does not open easily.

You attempted to re-open the

door immediately after closing.

Wait a few seconds between

closing and re-opening of the

door.

The lamp does not work.

The lamp is in stand-by mode.

Close and open the door.

The lamp is defective.

Contact the nearest Author-

ized Service Centre.

There is too much frost and

ice.

The door is not closed correct-

ly.

Refer to "Closing the door"

section.

The gasket is deformed or

dirty.

Refer to "Closing the door"

section.

Food products are not wrap-

ped properly.

Wrap the food products better.

Temperature is set incorrectly.

Refer to "Control panel" chap-

ter.

Appliance is fully loaded and is

set to the lowest temperature.

Set a higher temperature. Re-

fer to "Control panel" chapter.

14