Zanussi ZNNN18ES3, User Manual

necessary to allow door opening to the minimum

angle permitting removal of all internal equipment

LOCATION
To ensure appliance's best functionality, you should

not install the appliance in a place with direct

sunlight. Do not install the appliance close to

radiators or cookers, ovens, or hobs, unless

otherwise specified in the installation instructions.
Make sure that air can circulate freely around the

back of the cabinet.
This appliance should be installed in a dry, well

ventilated indoor position.
This appliance is intended to be used at ambient

temperature ranging from 10°C to 43°C.

The correct operation of the appliance

can only be guaranteed within the

specified temperature range.

If you have any doubts regarding

where to install the appliance, please

turn to the vendor, to our customer

service or to the nearest Authorised

Service Centre.

It must be possible to disconnect the

appliance from the mains power

supply. The plug must therefore be

easily accessible after installation.

ELECTRICAL CONNECTION

CAUTION! Any electrical work

required to install this appliance

should be carried out by a qualified

electrician or competent person.

WARNING! This appliance must be

earthed.

The manufacturer declines any liability

should these safety measures not be

observed.

The wires in the mains lead are coloured in

accordance with the following code:

A

B

C

D

E

• A - green and yellow: Earth

• C - brown: Live

• D - blue: Neutral
As the colours of the wires in the mains lead of this

appliance may not correspond with the coloured

markings identifying the terminals in your plug,

proceed as follows:

1. Connect the wire coloured green and yellow to

the terminal marked either with the letter “E“ or
by the earth symbol   or coloured green and

yellow.

2. Connect the wire coloured blue to the terminal

either marked with the letter “N“ or coloured

black.

3. Connect the wire coloured brown to the

terminal either marked with the “L“ or coloured

red.

4. Check that no cut, or stray strands of wire is

present and the cord clamp (E) is secure over

the outer sheath.

Make sure the electricity supply voltage is the

same as that indicated on the appliance rating

plate.

5. Switch on the appliance.

The appliance is supplied with a 13 amp fuse (B).

In the event of having to change the fuse in the plug

supplied, a 13 amp ASTA approved (BS 1362)

fuse must be used.

WARNING! A cut off plug inserted

into a 13 amp socket is a serious

safety (shock) hazard. Ensure that it is

disposed of safely.

VENTILATION REQUIREMENTS
The airflow behind the appliance must be sufficient.

7