20
Something not working
SYMPTOM
The oven does not come on.
The oven light does not come on.
It takes too long to finish the dishes, or they are
cooked too fast.
Steam and condensation settle on the food and the
oven cavity.
The timer does not work.
The oven fan is noisy.
Error code "E40" appears on the control panel.
An error code other than "E40" appears on the
control panel.
The display shows "12.00".
SOLUTION
Press the OVEN ON button, then select a cooking
function.
Check the fuse and ensure the socket switch or the
switch from the mains supply to the oven are ON.
Switch on the oven using push button 1.
Check the light bulb, and replace it if necessary (see
"Replacing the Oven Light")
The temperature may need adjusting
Refer to the cooking function sections and to any
cooking chart provided
Leave dishes inside the oven no longer than 15-20
minutes after the cooking is completed.
Check the instructions for the timer.
Check that shelves and bakeware are not vibrating in
contact with the oven back panel.
Switch the appliance off and leave it to cool down.
Push button ON / OFF to switch on the appliance.
Take note of the error code and contact an authorised
Service Centre.
Set the time of day (see chapter "How the set the time
of day").
If the oven is not working correctly, please carry out the following checks, before contacting your local Zanussi Service
Force Centre.
IMPORTANT:
If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation,
a charge will be made even if the appliance is under guarantee.
Service and Spare Parts
In the event of your appliance requiring service, or if you
wish to purchase spare parts, please contact your local
Zanussi Service Force Centre by telephoning:
0870 5 929929
Your telephone call will be automatically routed to the
Service Force Centre covering your post code area.
For the address of your local Service Force Centre and
further information about Service Force, please visit the
website at www.serviceforce.co.uk
Before calling out an engineer, please ensure you have
read the details under the heading “Something Not Work-
ing.”
When you contact the Service Force Centre you will need
to give the following details:
1. Your name, address and post code
2. Your telephone number
3. Clear and concise details of the fault
4. The model and serial number of the appliance (found
on the rating plate)
5. The purchase date
