3
Close the oven
door to the first open-
ing position (halfway).
Then pull forward and
remove the door from
its seat.
4
Put the door on a
soft cloth on a stable
surface.
5
Release the lock-
ing system to remove
the internal glass pan-
el.
90°
6
Turn the two fas-
teners by 90° and re-
move them from their
seats.
1
2
7
Carefully lift (step
1) and remove (step
2) the glass panel.
Clean the glass panel with water and soap. Dry
the glass panel carefully.
Installing the door and the glass panel
When the cleaning is completed, install the
glass panel and the oven door. Do the above
steps in the opposite sequence.
The screen-printing zone must face the inner
side of the door. Make sure that after the instal-
lation the surface of the glass panel frame on
the screen-printing zones is not rough when you
touch it.
Make sure that you install the internal glass pan-
el in the seats correctly. Refer to the illustration.
What to do if…
Warning!
Refer to the Safety chapters.
Problem
Possible cause
Remedy
The appliance does not operate.
The appliance is not activated.
Activate the appliance. Refer to
the chapter "Daily Use".
The appliance does not operate.
The fuse in the fuse box is re-
leased.
Do a check of the fuse. If the fuse
is released more than one time,
contact a qualified electrician.
The oven lamp does not operate.
The oven lamp is defective.
Replace the oven lamp.
12
www.zanussi.com
