Zanussi ZOG15311XK, User Manual

CAUTION!

Do not use the appliance without the

internal glass panel.

Open the door fully

and hold the two

door hinges.

1

Lift and turn the

levers on the two

hinges.

2

Close the oven door

halfway to the first

opening position.

Then pull forward and

remove the door from

its seat.

3

Put the door on a soft

cloth on a stable

surface.

4

2

B

1

Hold the door trim (B) on the top edge of the

door at the two sides and push inwards to

release the clip seal. Pull the door trim to the

front to remove it.

Hold the door glass panel by its top edge and

carefully pull it out. Make sure the glass slides

out of the supports completely.
Clean the glass panel with water and soap. Dry

the glass panel carefully.
When the cleaning is completed, install the

glass panel and the oven door. Do the above

steps in the opposite sequence.
The screen-printing zone must face the inner

side of the door. Make sure that after the

installation the surface of the glass panel frame

on the screen-printing zones is not rough when

you touch it.
Make sure that you install the internal glass

panel in the seats correctly.

A

Replacing the lamp

Put a cloth on the bottom of the interior of the

appliance. It prevents damage to the lamp glass

cover and the cavity.

WARNING!

Danger of electrocution! Disconnect

the fuse before you replace the

lamp.

The lamp and the lamp glass cover

can be hot.

CAUTION!

Always hold the halogen lamp with a

cloth to prevent grease residue from

burning on the lamp.

1. Deactivate the appliance.

2. Remove the fuses from the fuse box or

deactivate the circuit breaker.

The back lamp

1. Turn the lamp glass cover counterclockwise

to remove it.

2. Clean the glass cover.

www.zanussi.com

15