4. Put the door on a soft cloth on a stable surface.
5. Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal.
1
2
B
6. Pull the door trim to the front to remove it.
7. Hold the door glass panels by their top edge
and carefully pull them out one by one. Start
from the top panel. Make sure the glass slides
out of the supports completely.
8. Clean the glass panels with water and soap.
Dry the glass panels carefully.
When the cleaning is completed, install the glass
panels and the oven door. Do the above steps in
the opposite sequence.
Make sure that you put the glass panels (A, B and
C) back in the correct sequence. The middle panel
(B) has a decorative frame. The screen-printing
zone must face the inner side of the door. Make
sure that after the installation the surface of the
glass panel frame (B) on the screen-printing zones
is not rough when you touch it.
A
B
C
Make sure that you install the middle panel of glass
in the seats correctly.
A
B
C
REPLACING THE LAMP
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING! Danger of electrocution!
Disconnect the fuse before you
replace the lamp.
The lamp and the lamp glass cover
can be hot.
CAUTION! Always hold the halogen
lamp with a cloth to prevent grease
residue from burning on the lamp.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
4. Install the glass cover.
22
Summary of Contents for ZOP37982XC
Page 1: ...GETTING STARTED EASY User Manual ZOP37982XC EN User Manual Oven ...
Page 29: ...29 ...
Page 30: ...30 ...
Page 31: ...31 ...