32
INSTALLATION
If this appliance featuring magnetic door seals is to
replace an older appliance having a spring lock (latch) on
the door or lid, be sure to make that spring lock
unusable before you discard the old appliance.
This will prevent it from becoming a death-trap for a
child.
Positioning
The appliance should be installed well away from sources
of heat such as radiators, boilers, direct sunlight etc.
Best performance is obtained with ambient
temperature b18
°
C and +43
°
C (class T); +18
°
C
and +38
°
C (class ST); +16
°
C and +32
°
C (class N); +10
°
C
and +32
°
C (class SN).
The class of your appliance is shown on its rating plate.
For building into kitchen units follow the special
“Building-in” instructions given.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate correspond
to your domestic power supply.
Voltage can vary by
±
6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a contact
for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in compliance
with current regulations, consulting a specialist
technician.
The Manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with EEC directive number 87/308 of
2/6/87 relative to radio interference suppression.
This appliance complies with the following
E.E.C. Directives:
-
73/23 EEC
of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
-
89/336 EEC
of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Cleaning the interior
Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm
water and some neutral soap so as to remove the typical
smell of a brand-new product, then dry thoroughly.
Do not use detergents or abrasive powders, as these
will damage the finish.
Assembly instructions
Fitting the decor panel
(Fig. 1)
Preliminary requirement: the overall dimensions of
the decor panel must be 1-2 mm less than those of
the door, with a maximum thickness of 4 mm.
With the refrigerator door closed, unscrew the
screws securing the removable side piece of the
frame to the door. Remove this side piece and slide
the decor panel into place, after having slackened
the remaining frame screws; push the panel fully
home and secure the frame to the door, including the
side piece previously removed.
Fig. 1
Door reversal
Right hand door opening
Remove the upper and lower screws (1) and pivots
(2) with the safety washer (4) on the left side
(Fig. 2). Remove the door stop hinge (3-Fig. 3).
Fig. 2
Fig. 3
D243
D561
1
2
6
4
5
3
D562
