G
GB
B
55
Electrical connection
This refrigerator is designed to operate on a
230 V AC (~) 50 Hz supply.
The plug must be put into a socket with protective
contact. If there is no such, it is recommended to get
an electrician to fit an earthed socket in compliance
with standards near the refrigerator.
This appliance complies with the following
E.E.C. Directives:
73/23 EEC of 19.02.73 (Low Voltage Directive) and
subsequent modifications,
89/336 EEC of 03.05.89 (Electromagnetic
Compatibility Directive) and subsequent modifica-
tions.
Remove the lower hinge (e) by removing its screws (s)
and mount it on the other side. (fig.3)
Unmount the lower hinge pin (f) and its washer (h) and
mount them into the other hole of the lower hinge.
(fig.3)
Replace the plugs (u) on the other side.
Remove the covering nails (3 pieces) (n, k) of the dou-
ble door holder on the left side and put them to the
other side. (fig.2)
Fit the pin of the double door hinge (m) into the left
drill of the freezer door. (fig.2)
Fit the freezer door to the lower door hinge pin (f).
(fig.3)
Fit the refrigerator door to the upper door hinge pin
(d) then slightly tilting both doors fit the pin of the dou-
ble door hinge (m) into the left drill of the refrigerator
door.
Put the appliance to its place, set it level, and apply
voltage to it.
In case you do not want to perform the procedures above,
call the nearest brand-mark service.
Technicians will accomplish the refitting expertly for
charge.
Summary of Contents for ZRB 40NC
Page 59: ...59 ...
