Zanussi ZRB34NA, Instruction Book

37

Class of climate

Ambient temperature

SN

+10 ... +32 °C

N

+16 ... +32 °C

ST

+18 ... +38 °C

Ins

Ins

tr

tr

uctions f

uctions f

or the Ins

or the Ins

t

t

aller

aller

Technical data

Model

Gross capacity (l)

Net capacity (l)

Width (mm)
Height (mm)
Depth (mm)
Energy consumption (kWh/24h)

(kWh/year)

Energy class, according to EU standards
Freezing capacity (kg/24h)
Rising time (h)
Rated current (A)

Weight (kg)
Number of compressors

ZRB34NA

Freezer:       226

Refrigerator: 110

Freezer:       223  

Refrigerator: 92

595

1750

632

0,93

339

A
4

20

0,9

38
66

1

Installing the appliance

Transportation, unpacking

It is recommended to deliver the appliance in orig-
inal packaging, in vertical position considering the

protective warning on packaging.

After each transportation the appliance must not be
switched on for approx. 2 hours.

Unpack the appliance and check if there are damages on
it. Report possible damages immediately to the place you
bought it. In that case retain packaging.

Cleaning

Remove every adhesive tape and everything else, which
ensure the accessories not to move in the appliance.

Wash the inside of the appliance using lukewarm water
and mild detergent. Use soft cloth.

After cleaning wipe out the inside of the appliance.

Placement

The ambient temperature has an effect on the energy
consumption and proper operation of the appliance.
When placing, take into consideration that it is practical
to operate the appliance between ambient temperature
limits according to the climate class that is given in the
chart below and can be found in the data label.

If the ambient temperature goes below the lower data the
temperature of the cooling compartment can go beyond
the prescribed temperature.

If the ambient temperature goes beyond the upper data
this means longer operating time of the compressor,
breakdown in the automatic defrosting increasing temper-
ature in the cooling compartment or increasing energy
consumption.

Mount the spacers supplied in the plastic bag of the
accessories. Hold the spacer as shown on the Fig.,
knock it home, then turn it by 90°. (Into the oval holes
of back side of the appliance.)

When placing the appliance ensure that it stands level.
This can be achieved by two adjustable feet at the bottom
in front. 

EN