Zanussi ZRB35312WA, User Manual

Problem

Possible cause

Solution

The room temperature is too

high.

Refer to climate class chart on the

rating plate.

Food products placed in the

appliance were too warm.

Allow food products to cool to

room temperature before storing.

The door is not closed correct-

ly.

Refer to "Closing the door".

The QuickFreeze function is

switched on.

Refer to "QuickFreeze function".

The compressor does not start

immediately after pressing the

QuickFreeze, or after changing

the temperature.

This is normal, no error has oc-

curred.

The compressor starts after a peri-

od of time.

Water flows inside the refrigera-

tor.

The water outlet is clogged.

Clean the water outlet.

Food products prevent that

water flows into the water col-

lector.

Make sure that food products do

not touch the rear plate.

Water flows on the floor.

The melting water outlet is not

connected to the evaporative

tray above the compressor.

Attach the melting water outlet to

the evaporative tray.

Temperature cannot be set.

The QuickFreeze or QuickChill

function is switched on.

Switch off QuickFreeze or Quick-

Chill manually, or wait until the

function resets automatically to set

the temperature. Refer to "Quick-

Freeze or QuickChill function".

The temperature in the appliance

is too low/too high.

The temperature regulator is

not set correctly.

Set a higher/lower temperature.

The door is not closed correct-

ly.

Refer to "Closing the door".

The food products' tempera-

ture is too high.

Let the food products temperature

decrease to room temperature be-

fore storage.

Many food products are stored

at the same time.

Store less food products at the

same time.

The door has been opened of-

ten.

Open the door only if necessary.

The QuickFreeze function is

switched on.

Refer to "QuickFreeze function".

There is no cold air circulation

in the appliance.

Make sure that there is cold air cir-

culation in the appliance.

www.zanussi.com

11