Problem
Possible cause
Solution
The compressor does not start
immediately after pressing the
QuickChill, or after changing the
temperature.
This is normal, no error has oc-
curred.
The compressor starts after a pe-
riod of time.
Water flows on the rear plate of
the refrigerator.
During the automatic defrosting
process, frost melts on the rear
plate.
This is correct.
Water flows inside the refrigera-
tor.
The water outlet is clogged.
Clean the water outlet.
Food products prevent that water
flows into the water collector.
Make sure that food products do
not touch the rear plate.
Water flows on the floor.
The melting water outlet is not
connected to the evaporative tray
above the compressor.
Attach the melting water outlet to
the evaporative tray.
Temperature cannot be set.
The or QuickChill function is
switched on.
Switch off or QuickChill manual-
ly, or wait until the function resets
automatically to set the tempera-
ture. Refer to " or QuickChill
function".
The temperature in the appliance
is too low/too high.
The temperature regulator is not
set correctly.
Set a higher/lower temperature.
The door is not closed correctly.
Refer to "Closing the door".
The food products' temperature
is too high.
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Many food products are stored at
the same time.
Store less food products at the
same time.
The door has been opened often. Open the door only if necessary.
The QuickChill function is
switched on.
Refer to "QuickChill function".
There is no cold air circulation in
the appliance.
Make sure that there is cold air
circulation in the appliance.
All the temperature setting LEDs
flash at the same time.
An error has occurred in measur-
ing the temperature.
Contact the nearest Authorized
Service Centre. The cooling sys-
tem will continue to keep food
products cold, but temperature
adjustment will not be possible.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
www.zanussi.com
11
Summary of Contents for ZRB38338WA
Page 41: ...www zanussi com 41 ...
Page 42: ...42 www zanussi com ...
Page 43: ...www zanussi com 43 ...