8. Open the door. Make sure that the light comes on.
2
1
3
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets.
Contact the Service Force Center.
Technical data
Dimension
Height
1850 mm
Width
595 mm
Depth
632 mm
Rising Time
18 h
The technical information are situated in the rating plate
on the internal left side of the appliance and in the en-
ergy label.
Installation
Caution!
Read the "Safety Information" carefully
for your safety and correct operation of the
appliance before installing the appliance.
Positioning
Install this appliance at a location where the ambient
temperature corresponds to the climate class indicated
on the rating plate of the appliance:
Climate
class
Ambient temperature
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Location
The appliance should be installed well away from sour-
ces of heat such as radiators, boilers, direct sunlight
etc. Ensure that air can circulate freely around the back
of the cabinet. To ensure best performance, if the ap-
pliance is positioned below an overhanging wall unit,
the minimum distance between the top of the cabinet
and the wall unit must be at least 100 mm . Ideally,
however, the appliance should not be positioned below
overhanging wall units. Accurate levelling is ensured
by one or more adjustable feet at the base of the cab-
inet.
Warning!
It must be possible to disconnect the
appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
A
B
min.100 mm
20 mm
11
