Electrical Connection
Caution!
Any electrical work required to install
this appliance should be carried out by a qualified
electrician or competent person.
Warning!
This appliance must be earthed.
The manufacturer declines any liability should
these safety measures not be observed.
1
2
3
4
5
Important!
The wires in the mains lead are coloured
in accordance with the following code:
1
Green and Yellow:
Earth
3
Brown:
Live
5
Blue:
Neutral
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured mark-
ings identifying the terminals in your plug, proceed as
follows:
1. Connect the wire coloured green and yellow to the
terminal marked either with the letter “E“ or by the
earth symbol or coloured green and yellow.
2. Connect the wire coloured blue to the terminal ei-
ther marked with the letter “N“ or coloured black.
3. Connect the wire coloured brown to the terminal
either marked with the “L“ or coloured red.
4. Check that no cut, or stray strands of wire is present
and the cord clamp
4
is secure over the outer
sheath.
5. Make sure the electricity supply voltage is the same
as that indicated on the appliance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug fitted
2
. In the event of having to change the fuse in the
plug supplied, a 13 amp ASTA approved (BS 1362)
fuse must be used.
Warning!
A cut off plug inserted into a 13 amp
socket is a serious safety (shock) hazard. Ensure
that it is disposed of safely.
Rear spacers and levelling
1
2
3
In the bag with the docu-
mentation, there are two
spacers which must be
fitted as shown in the fig-
ure.
Slacken the screws and
insert the spacer under
the screw head, then
tighten again the screws.
When placing the appli-
ance ensure that it
stands level. This can be
achieved by two adjusta-
ble feet at the bottom in
front.
Removing the shelf holders
Your appliance is equipped with shelf retainers that
make it possible to secure the shelves during trans-
portation.
To remove them proceed as follows:
1. Move the shelf holders in the direction of the arrow
(A).
12
