Zanussi ZUNN26FW, User Manual

Problem

Possible cause

Solution

Water flows on the floor.

The melting water outlet is not

connected to the evaporative

tray above the compressor.

Attach the melting water outlet

to the evaporative tray.

Temperature cannot be set.

The "FastFreeze function" is

switched on.

Switch off "FastFreeze func-

tion" manually, or wait until the

function deactivates automati-

cally to set the temperature.

Refer to "FastFreeze function"

section.

The temperature in the appli-

ance is too low/too high.

The temperature is not set cor-

rectly.

Set a higher/lower tempera-

ture.

The door is not closed correct-

ly.

Refer to "Closing the door"

section.

The food products' tempera-

ture is too high.

Let the food products temper-

ature decrease to room tem-

perature before storage.

Many food products are stored

at the same time.

Store less food products at the

same time.

The door has been opened of-

ten.

Open the door only if necessa-

ry.

The FastFreeze function is

switched on.

Refer to "FastFreeze function"

section.

There is no cold air circulation

in the appliance.

Make sure that there is cold air

circulation in the appliance.

Refer to "Hints and Tips" chap-

ter.

DEMO appears on the display.

The appliance is in demonstra-

tion mode.

Keep the OK key pressed for

approximately 10 seconds until

a long sound is heard and the

display turns off for a short

time.

A   or   or   symbol is

shown instead of numbers on

the temperature display.

Temperature sensor problem.

Contact the nearest Author-

ized Service Centre (the cool-

ing system will continue to

keep food products cold, but

temperature adjustment will

not be possible).

If the advice does not lead to the

desired result, call the nearest

Authorized Service Centre.

CLOSING THE DOOR

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

installation instructions.

3. If necessary, replace the defective door

gaskets. Contact the Authorised Service

Centre.

14