Zanussi ZUNN26FW, User Manual

This appliance is not intended to be used as a built-

in appliance.
In case of different installation from freestanding

respecting space required in use dimensions, the

appliance will function correctly but energy

consumption might increase slightly.
To ensure appliance's best functionality, you should

not install the appliance in the nearby of the heat

source (oven, stoves, radiators, cookers or hobs) or

in a place with direct sunlight. Make sure that air

can circulate freely around the back of the cabinet.
This appliance should be installed in a dry, well

ventilated indoor position.
To ensure best performance, if the appliance is

positioned below an overhanging wall unit, the

minimum distance between the top of the cabinet

shall be maintained. Ideally, however, the appliance

should not be positioned below overhanging wall

units. One or more adjustable feet at the base of

the cabinet ensure that the appliance stands level.

CAUTION! If you position the

appliance against the wall, use back

spacers provided or keep the minimum

distance indicated in the installation

instructions.

CAUTION! If you install the appliance

next to a wall, refer to the installation

instructions to understand the

minimum distance between the wall

and the side of the appliance where

door hinges are to provide enough

space to open the door when the

internal equipment is removed (e.g.

when cleaning).

This appliance is intended to be used at ambient

temperature ranging from 10°C to 43°C.

The correct operation of the appliance

can only be guaranteed within the

specified temperature range.

If you have any doubts regarding

where to install the appliance, please

turn to the vendor, to our customer

service or to the nearest Authorised

Service Centre.

It must be possible to disconnect the

appliance from the mains power

supply. The plug must therefore be

easily accessible after installation.

ELECTRICAL CONNECTION
• Before plugging in, ensure that the voltage and

frequency shown on the rating plate correspond

to your domestic power supply.

• The appliance must be earthed. The power

supply cable plug is provided with a contact for

this purpose. If the domestic power supply

socket is not earthed, connect the appliance to

a separate earth in compliance with current

regulations, consulting a qualified electrician.

• The manufacturer declines all responsibility if

the above safety precautions are not observed.

• This appliance complies with the E.E.C.

Directives.

REAR SPACERS
You can find the two spacers in the bag with

documentation.

1. Release the screw.

2. Engage the spacer below the screw.

3. Turn the spacer to the right position.

4. Tighten again the screws.

2

4

3

1

DOOR REVERSIBILITY
Please refer to the separate document with

instructions on installation and door reversal.

CAUTION! At every stage of reversing

the door protect the floor from

scratching with a durable material.

7