Zanussi ZUT 143W1, Instruction Book

16

Refit the upper hinge pin into the opposite location.

Fit the door in place on the hinge pin.

Slot the hinge pin into the hole in the hinge plate
and relocate the hinge assembly to the opposite
location and refit using the retaining screws.

Refit the bottom hinge plate assembly on the
opposite side, taking care that the edge of the door
is parallel with the side of the cabinet.

To reverse the handle proceed as follows:

Remove screw covers (if fitted) and handle retaining
screws. Remove blanking plugs on the opposite
side

using a punch.

Relocate the handle to the opposite side and refit
retaining screws (covers if fitted), and 

push the

plastic plugs supplied with the instruction book into
the holes where the handle was previously fitted.

Electrical Connection

Electrical Connection

Any electrical work required to install this
appliance should be carried out by a
qualified electrician or competent person.

This appliance must be earthed.

The manufacturer declines any liability should
these safety measures not be observed.

Electrical Requirements

Before switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance
rating plate.

The appliance is supplied with a 13 amp plug fitted. In
the event of having to change the fuse in the plug
supplied, a 13 amp ASTA approved (BS 1362) fuse
must be used. Should the plug need to be replaced