14
¥
Before calling your local dealer for servicing
assistance, check the following points to see if
you may not resolve the problem yourself:
¥
Make sure that the freezer is plugged into the
wall socket correctly, and that electrical current
arrives to the freezer without interruption.
¥
Control the thermostat setting.
¥
In the event that the freezer makes excessive
noise or vibration, make sure that it is not in direct
contact with the wall or adjacent furniture.
¥
If defective operation continues after these
controls, call your local Service Network and
provide all the data listed on the rating plate:
model, serial number, etc.
CUSTOMER SERVICE AND SPARE PARTS
INSTALLATION
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Best performance is obtained with
ambient temperature between
+18¡C and +43¡C(class T);
+18¡C and +38¡C (class ST);
+16¡C and +32¡C (class N);
+10¡C and +32¡C (class SN).
The class of your appliance is shown on its
rating plate.
Ensure that air can circulate freely around the back
of the cabinet. To ensure best performance, if the
appliance is positioned below an overhanging wall
unit, the minimum distance between the top of the
cabinet and the wall unit must be at least 100 mm
(A). Ideally, however, the appliance should not be
positioned below overhanging wall units (B).
Accurate levelling is ensured by one or more
adjustable feet at the base of the cabinet.
Important
It is essential that the appliance be connected to an
efficient earth tap. For this purpose the supply cable
plug incorporates a special earth contact. If the
sockets of your domestic wiring system are not
earthed, have the appliance connected to a separate
earth wire by a qualified electrician in accordance
with existing safety regulations.
The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with EEC directive
number 87/308 of 2/6/87 relative to radio
interference suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC
of 19.2.73 (Low Voltage Directive) and
subsequent mod)fications;
- 89/336 EEC
of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply. Voltage
can vary by ±6% of the rated voltage.
100 mm
10 mm
10 mm
A
B
NP006
