15
Rear spacers
The plastic bag containing all relevant documentation
also contains two rear wall spacers to be fitted into spe-
cial slots on the back of the appliance. Fit the spacers
into the slots, taking care to ensure that the arrow (A) is
positioned as shown in the figure. Next, turn them
through 45¡ (arrow in vertical position) until they lock into
place.
Door reversal
Unplug the appliance before all operations.
To reverse the door, proceed as follows:
1. dismantle the lower hinge (3), pin (1) and the screw
(2);
2. slide the door out from pin (D),unscrew the pin and
reposition on the opposite side;
3. unscrew the left front foot and reposition on the oppo-
site side;
4. unscrew the two screws which mask the holes for fix-
ing the hinge from the left front side;
5. reassemble the door;
6. reassemble the lower hinge (turning it 180¡), the pin
and the screw on the opposite side, as shown in the
figure;
7. remove the handle, after having removed the screw
cover and refit it on the opposite side. The holes that
are not used must be mask with the plastic plugs
removed.
Warning:
After having reversed the opening direction of the
doors check that all the screws are properly tight-
ened and that the magnetic seal adheres to the cabi-
net.
If the ambient temperature is cold (i.e. in Wõnter), the
gasket may not fit perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket or accelerate this
process by heating up the part involved with a normal
hairdrier.
Fitting the door panel
(for models equipped with door frame)
To fit the door panel, proceed as follows:
¥
remove the fixing screws and remove the frame side
opposite the handle;
¥
loosen, without removing them, all remaining screws
fixing the door frame;
¥
insert the panel from the side on which the frame has
been removed and push it fully in;
¥
refit the frame side and tighten all the screws.
Note
The panel size should be 1-2 mm smaller than the door;
the maximum permissible panel thickness is 4 mm.
PR60
A
45
°
D
D590
180
°
1
3
2
D299
2
