34
INSTALLATION
If this appliance – equipped with magnetic door
seals – replaces an older appliance featuring a
spring lock (mechanical latch) on the door or lid,
please ensure that this lock is made completely
unusable before «throwing out» the old appliance.
This will prevent it from becoming a death-trap for
a child.
Location
Place the appliance as far away as possible from
sources of heat, e.g. radiators, heaters, direct
sunlight, etc. The best results are achieved with a
room temperature of b10
°
C and +32
°
C.
Make sure that there is nothing hindering air
circulation at the back, bottom or top of the
appliance.
For safety reasons, minimum ventilation must be as
shown in Fig. 1:
Appliance positioned under overhanging kitchen
wall units (see Fig. 1-A).
Appliance positioned without overhanging kitchen
units (see Fig. 1-B).
Attention: keep ventilation openings clear of obstruction.
One or more adjustable feet mounted on the base of
the appliance make it possible to set it perfectly
level.
Fig. 1
Rear spacers
In the bag with the documentation, there are two spacers
which must be fitted as shown in the figure.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.
D524
A
B
min.
50 cm
2
min.
50 cm
2
min.
50 cm
2
Fig. 1a
Power connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by
±
6% of the rated voltage.
For operation with different voltages, a suitably
sized auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
The Manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with EEC directive number 87/
308 of 2/6/87 relative to radio interference suppression.
This appliance complies with the following
E.E.C. Directives:
-
73/23 EEC
of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
-
89/336 EEC
of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Cleaning the appliance’s interior
Before using the appliance for the first time, wash
all internal parts with lukewarm water and neutral
soap so as to remove the typical «new» smell and
then dry thoroughly. Do not use detergents or
abrasive powders as these will damage the finish.
PR153
