35
Door reversibility
Unplug the freezer before performing the following
operations:
Remove the ventilation grill (D).
Remove the lower hinge (E) by loosening the two
fastening screws.
Fig. 2
Remove the door by sliding it out of the upper pin
(A-Fig. 3).
Unscrew the pin and the washer (A+B-Fig. 3) and
refit them on the opposite side.
Fig. 3
Refit the door.
Refit the lower hinge (E-Fig. 2) on the opposite side
by means of the two screws that have been
previously removed.
Remove the plug (F) from the ventilation grill (D)
and replace it on the opposite side.
Refit the ventilation grill.
E
F
D
D640
F
F
F
C
B
A
D427
Remove the handle and refit it on the opposite side
(Fig. 4).
Fig. 4
The holes that are not used are to be masked with
the plastic plugs removed.
If, after having reversed the door, it is not in line
with the unit, the top hinge can be adjusted.
To do this, use a 10 mm spanner as shown in
Figure 3; slacken the nut, align the door by pushing
it to the left or right, then re-tighten the nut.
Attention
After having reversed the opening direction of the door
check that all the screws are properly tightened and that
the magnetic seal adheres to the cabinet.
If the ambient
temperature is cold (i.e. in Winter), the gasket may
not fit perfectly to the cabinet. In that case, wait for
the natural fitting of the gasket or accelerate this
process by heating up the part involved with a
normal hairdrier.
D162
